Technics SU-G30 Operating Instructions Manual page 21

Using the WPS PIN code
"WPS PIN"
If your wireless router supports WPS, you can set
up a connection by entering the WPS PIN code.
• For details on how to enter the PIN code, refer
to the operating instructions of the wireless
router.
1 Press [ ], [ ] on the remote control to
select "WPS PIN" and then press [OK].
• The PIN code is displayed. Complete step 2
within 2 minutes.
2 Enter the PIN code into the wireless
router from PC, etc.
• "Linking" is displayed.
• When the connection is established,
"Success" is displayed.
- "Fail" may be displayed if the connection
was not complete. Try this method
again from [SETUP] menu. If "Fail" is still
displayed, try other methods ( 19).
3 Press [OK] on the remote control to
exit the setting.
• "
" is displayed.
Note
• Depending on a router, other connected
devices may temporarily lose their connection.
• For details, refer to the operating instructions of
the wireless router.
Using iPhone/iPad/iPod
"With iPod"
With this method you will share the wireless
network settings of your iPod/iPhone/iPad with
this system.
• Supported device:
iPhone/iPad/iPod touch (iOS version 5.0 or
later)
• The following explanations are based on an
iPhone.
• Make sure your iPhone is connected to your
home wireless network beforehand.
USB cable
(supplied with iPhone/iPad/iPod)
1 Connect the iPhone to this unit with
the USB cable.
• Use the USB cable supplied with iPhone/
iPad/iPod.
• Unlock your iPhone before connecting.
2 Press [ ], [ ] on the remote control
to select "With iPod" and then press
[OK].
• "Connecting Wi-Fi" is displayed.
3 Allow the iPhone to share the wireless
network settings.
• When the connection is established,
"Success" is displayed.
- "Fail" may be displayed if the connection
was not complete. Try this method
again from [SETUP] menu. If "Fail" is still
displayed, try other methods ( 19).
4 Press [OK] on the remote control to
exit the setting.
• "
" is displayed.
VOLUM
PHONES 5V 2.1A
21
Connections