Before Repair And Adjustment - Technics SE-HDA710 Service Manual

2000 Matsushita Electric Industrial Co., Ltd. / / All rights
reserved. Unauthorized copying and distribution is a violation of
law.
1. Accessories

2. Before Repair and Adjustment

1. Turn off the power supply. Using a 10
both ends of power supply capacitors (C102-105, 127) in order to
discharge the voltage.
2. Before turning the power supply on, after completion of repair,
slowly apply the primary voltage by using a power supply voltage
controller to make sure that the consumed current at 50/60 Hz in
NO SIGNAL mode should be shown below withrespect to supply
voltage 230 V/240 V.
Areas
Power supply voltage
Consumed current
(EG)
AC 230V
50 Hz 90-180 mA
, 10W resistor, connect
(EB)
AC 230-240V
50 Hz 90-180 mA