Technics SU-G30 Operating Instructions Manual page 19

Wireless LAN connection
■
Preparation
Disconnect the AC mains lead.
Disconnect the LAN cable.
Place this unit as close to the wireless router as
possible.
Point up the antenna on the rear of this unit as
shown in the figure.
PHONO LINE IN LINE IN
LAN
PHONO
EARTH OPT COAX1 COAX2 PC
10BASE-T /
DIGITAL IN 100BASE-TX
Connect the AC mains lead to this unit. ( 17)
Note
• Do not perform the following:
- Applying too much force to the antenna
- Carrying this unit by holding the antenna
• The setting will be cancelled after the set time
limit. In that case, try the setting again.
• To cancel this setting in the middle, press [
turn the unit to standby mode.
■
Settings for the first time
1 Press [ ] to turn this unit on.
• "Wi-Fi Setup" is displayed.
2 Press [ ], [ ] to select "On" and then
press [OK].
• "WAC Mode for iOS" automatically starts.
3 (For "WAC Mode for iOS")
Proceed to step 2 of "Using the WAC
(Wireless Accessory Configuration)"
( 20).
(For other network setting method)
Choose a network setting method.
Note
• When this unit is switched to standby mode and
turned on before the Wi-Fi setting is complete,
"Wi-Fi Setup" is displayed. Perform the Wi-Fi
setting or select "Off".
AC IN ∼
SPEAKERS
(4∼16Ω)
] or
■
Choose a network setting method
Are you using an iPod touch/iPhone/iPad?
Yes
(iOS version 7.0 or later)
Using the WAC (Wireless Accessory
Configuration) ( 20)
(iOS version 5.0 or later)
Using iPhone/iPad/iPod ( 21)
No
Does your wireless network router
support WPS (Wi-Fi Protected Setup™)?
Yes
(WPS button)
Using the WPS button ( 20)
(WPS PIN code)
Using the WPS PIN code ( 21)
No
Are you using an Android device?
Yes
Using "Technics Music App" ( 22)
No
Using an internet browser ( 22)
■
Settings using [SETUP] menu
1 Press [SETUP].
2 Press [ ], [ ] repeatedly to select
"Network" and then press [OK].
• When "Wi-Fi" screen is displayed, press [OK].
3 Press [ ], [ ] to select "On" and then
press [OK]. (The wireless LAN function
is enabled.)
4 Choose a network setting method.
19
Connections