Step 4: Sselecting Additional Functions - Asko BO6PY4I1-42 Operating Instructions Manual

STEP 4: SSELECTING ADDITIONAL FUNCTIONS

5sek
5sek
+
After a power outage or after the appliance is switched
off , the additional function settings will remain stored
for no more than a few minutes. Then, all settings,
except for the acoustic signal and child lock will be
reset to factory defaults.
14
CHILD LOCK
Activate it by touching the CHILD LOCK key. The "key" icon will light up on the display. Touch the key
again to deactivate the child lock. The icon on the display will disappear.
If the child lock is activated with no timer function engaged (only clock is displayed), then the oven will
not operate.If the child lock is activated after a timer function has been set, then the oven will operate
normally; however, it will not be possible to change the settings.
When the child lock is activated, systems (cooking modes) or additional functions cannot be changed.
The only possible change is to end the cooking process by rotating the selector knob to "0".Child lock
will remain active after the oven is switched off . To select a new system, the child lock must fi rst be
deactivated.
OVEN LIGHTING
Oven lighting is switched on automatically when the door is opened or when the oven is switched on.
After the end of the cooking process, the light will remain on for another minute.
The light inside the oven can be switched on or off by pressing the LIGHT key.
ACOUSTIC SIGNAL
Loudness of the acoustic signal can be set when no timer function is activated (only the time of day is
displayed).
Press the TEMPERATURE/POWER key and hold it for 5 seconds. Two fully lit bars will appear on the
display. Rotate the SETTINGS KNOB (-/+) to choose one of the three volume levels (one, two, or three
bars). After three seconds, the setting will be automatically stored and the time of day will appear.
DECREASING THE DISPLAY CONTRAST
The cooking system selector knob should be on the "0" position.Press the LIGHT key and hold it for 5
seconds. Two fully lit bars will appear on the display. Rotate the SETTINGS KNOB (-/+) to adjust the
display dimmer (one, two, or three bars). After three seconds, the setting will be automatically saved.
STANDBY
Display lighting can be automatically switched off after 10 minutes if it is not used.Press the KEY +
TIMER keys to switch off the display. If a timer function has been activated, then "OFF" and the TIMER
icon will appear on the display to indicate the activated function.
Activate/deactivate the functions by pressing the
desired key or a combination of keys.
Some functions are not available with some
systems; an acoustic signal will indicate of such cases.