Table of Contents
Advertisement
CAUTIONS ON INSTALLATION
Model No. of ceiling mount bracket: ET-PKB2
When mounting the projector on the ceiling with the ceiling mount bracket, install the provided wire rope to the
bottom of the projector. (There is no problem in safety, but this should be done to prevent an unexpected accident
in case a screw gets loose.)
Ensure to use a torque driver and do not use an electrical screwdriver or an impact screwdriver.
Remove an unused ceiling mount bracket promptly.
For details, see the work instruction manual packed together with the ceiling mount bracket.
NOTE:
Even if it is during guaranteed period, the manufacturer is not responsible for any hazard or damage caused by using a ceiling
mount bracket which is not purchased from an authorized distributors, or environmental conditions.
The model Nos. of the accessories and the parts sold separately are subject to change without notice.
Installing the safety cable
1
Torque: 1.25 ± 0.2 N.m
2
Lace the cable of the end with a latch through the loop on the other end of the cable.
Pass through
the ring
M4 × 0.7
9 mm
ENGLISH
57
Advertisement
Table of Contents
