Table of Contents
Advertisement
Turn the projector ON or OFF (continued)
TURN THE PROJECTOR OFF
When operating the projector, check the status of the POWER indicator. (
1
Press the POWER button.
screen will go off and return to projection if there
is no operation for approximately 10 seconds.
2
Press the button again.
The lamp goes off and the projection stops.
The cooling fan continues its rotation and
POWER indicator lights orange. Wait until the
POWER indicator turns red.
If STANDBY MODE is set to NORMAL, the
POWER
STANDBY
(
R
)
ON
(
G
)
POWER indicator
(
page 39)
1 ) 2 )
page 21)
3
Disconnect the power plug from the wall
outlet after the POWER indicator turns red.
(
page 21)
For urgency, you may disconnect the power
plug immediately since the DIRECT POWER
OFF function is installed.
NOTE:
CONTROL PANEL (when operating with
the projector body) or REMOTE CONTROLLER (when
operating with the remote control) under CONTROL
DEVICE SETUP in the SECURITY menu is set to ENABLE.
(
page 44)
Power can be turned off by pressing [POWER] for
at least 0.5 seconds.
ENGLISH
23
Advertisement
Table of Contents
