Table of Contents
Advertisement
Details of your projector (continued)
Rear and bottom view
Terminals
Air intake port
AC IN
Connect the power cord to supply electric power to
the projector. (
page 20)
Leg adjuster
To adjust the projection angle. (
NOTE:
Do not connect any power cable other than the attached one.
Do not cover the ventilation openings of the air intake port.
Terminals
Connect to a network cable.
(See "Network Operation Manual".)
Connect to a computer to control the projector's
operation.
(
page 19, 53)
Connect to a computer or YP
(
page 19)
Connect to an S-VIDEO signal cable.
(
page 18)
NOTE:
Do not place your hands or other objects close to the air outlet port as this may cause damage or injury.
Do not place your hands or face, or objects which cannot withstand heat near the air outlet port. Hot air comes out
from this port.
14
ENGLISH
(
page 46)
page 24)
COMPUTER 1 IN
SERIAL
LAN
COMPUTER 2 IN
P
signal cable.
B
R
Air intake port
Burglar hook port
Attach a commercial burglar prevention cable.
S-VIDEO
AUDIO
IN
OUT
1
2
VIDEO IN
AUDIO IN
Connect to a VIDEO signal cable.
(
page 18)
Connect audio cables for inputting audio signal.
(
page 19)
Connect an audio cable for audio signal output
to the connected equipment. If it is connected to
this terminal, no sound comes out of the built-in
speaker.
(
page 18, 19)
(
page 48)
Advertisement
Table of Contents
