11
SERVICE WORK ON THE CHASSIS
(XC‑F)
–
Position the fork legs.
Position bleeder screws
B01422-10
–
Tighten screws
Guideline
Screw, bottom triple clamp
B01466-10
–
Tighten screw
Guideline
Screw, top steering head
B01467-10
–
Mount and tighten screw
Guideline
Screw, top steering stem
B01467-11
–
Using a plastic hammer, tap lightly on the upper triple clamp to avoid strains.
–
Tighten screws
Guideline
Screw, top triple clamp
B01466-11
–
Position the brake caliper. Mount and tighten screws
Guideline
Screw, front brake caliper
–
Position the brake line and clamp. Mount and tighten screws
B00379-10
Finishing work
–
Install the front fender. (
toward the front.
5
Info
The rebound damping is located in the right fork leg (red adjusting
screw). The compression damping is located in the left fork leg (white
adjusting screw).
Grooves are milled into the side of the upper end of the fork legs. The
second milled groove (from the top) must be flush with the top edge of
the upper triple clamp.
.
6
.
4
.
7
M8
.
8
M8
p. 43)
M8
12 Nm (8.9 lbf ft)
M20x1.5
12 Nm (8.9 lbf ft)
17 Nm
Loctite
(12.5 lbf ft)
M8
17 Nm
(12.5 lbf ft)
.
9
25 Nm
Loctite
(18.4 lbf ft)
.
bk
40
®
243™
®
243™