View Checklists; View Messages; Set Com And Nav Frequencies - Garmin CNX 80 Pilot's Manual

Getting Started
14
The database information can be checked after start-up in the SW Version page of the System function. Press
the Menu/Enter key to continue after you have verified the dates. Valid databases are in green. The database
being used has an asterisk (*) next to it, if there are two databases. Expired databases are amber.

View Checklists

Use a checklist to review preparation for flight.
1. Press FN and then the CHK function smart key.
2. Turn the Large knob to select the desired list and press Menu/Enter.
3. Press CHCK or Menu/Enter as you check each item on the list. The next item in the list will then be
highlighted. Checking the last item will take you back to the main Checklist page.

View Messages

You can review system messages by pressing the MSG function smart key. Turn the Large knob to switch
between New and Old messages. Turn the Small knob to scroll through the available messages. The Message
annunciator (M) will flash until all unread messages have been read. While old messages exist and there are
no new messages, the Message annunciator will remain solid. The Message annunciator will not appear when
there are no messages.

Set Com and Nav Frequencies

You can set the Com and Nav frequencies manually
1. Press Com for VHF Com frequencies or press VOR for VOR/LOC/ILS frequencies.
2. Turn the Large knob to select MHz and turn the Small knob for kHz of the stand-by frequency.
3. Press the <—> key to flip-flop the active and stand-by frequencies.
4. Press MON to toggle monitoring of the stand-by frequency.
5. Turn the PWR/VOL knob to adjust the audio level.