Insert En Route Flight Plan Airways And/Or Waypoints; Modifying A Flight Plan While In Flight - Garmin CNX 80 Pilot's Manual

Basic Operation
Flight Planning
64
4. The runway is highlighted. Use the Small knob or menu item keys on the right side of the display to
select a runway.
5. Turn the Large knob to select the departure procedure and transition.
6. Verify your flight plan and resolve any discontinuities. Press Menu/Enter to insert the procedure into
your modified flight plan.
C. Insert En Route Flight Plan Airways and/or Waypoints
1. While in Edit mode, turn the Large knob CW to highlight the waypoint where you want to insert a waypoint
or Airway in your flight plan after it. Press →Wpt or →Arwy. In this example, Airway is selected.
2. Turn the Small knob or press one of the Menu Item keys next to the available airways to select the
airway.
3. Turn the Large knob CW one position to highlight the Intersection choices. Turn the Small knob to
choose the desired waypoint to exit the Airway. Press Menu/Enter.
D. Modifying a Flight Plan While In Flight
Flight plans may be modified in either the Flight Plan (FPL) or Procedure (PROC) modes. In Flight Plan mode
you can modify the entire flight plan. In Procedure mode you can modify procedures for the Origin and Desti-
nation airports. Both methods are shown below.
Using Flight Plan Mode to Modify a Flight Plan
1. Press the FN key and then the FPL key.
2. If necessary, highlight the Active flight plan. Press the EDIT key.
3. If you want to change the Origin, Destination, or Alternate airports, press the appropriate selection key
on the left side of the display when the flight plan name is highlighted. If you want to insert a waypoint
or airway, go to step 5.
4. Turn the Large knob to highlight the leg where you want to make the change.
5. Press →Wpt to insert a waypoint or →Arwy to insert an airway following the highlighted leg. If the
airway choice is not available there are no airways available for that waypoint. Delete a waypoint or
airway by pressing the CLR key.
6. Press XPND to display all of the legs of the flight plan.
7. Review your flight plan to resolve any discontinuities as desired and then press the EXEC key to
execute.