Test Log - Garmin CNX 80 Pilot's Manual

Test Log

The Test Log function allows you to store information about the last time you tested your Nav receiver. The
information you can enter includes: Date (month, day, year), Type of test (Differential, Ground, Air), Location
(text), Bearing Error (-5 to +5), and name of person logging the test information (text).
1. In the Nav function, Press Menu/Enter and then the Test Log key.
2. Press the EDIT key. The month of the Date will be highlighted.
3. Turn the Small knob the change the month of the date. Turn the Large knob to move to Day of the
Date.
4. Turn the Small knob to change the day. Turn the Large knob to move to the year. Turn the Small knob
to change the year.
5. Turn the Large knob to move to the Type selection. Turn the Small knob to choose between
Differential, Ground, or Air. Differential means the value was referenced to another calibrated source
or unit. Ground means the unit was calibrated while on the ground. Air means the unit was calibrated
while in the air.
6. Turn the Large knob to move to the Location selection. Press the Cursor knob in to start editing. Turn
the Small knob to change the character. Turn the Large knob to the next character and turn the Small
knob to change the character. When editing is complete, press the Cursor knob again to exit editing
the Location.
7. Turn the Large knob to move to the Brg Error selection. Turn the Small knob the change the value
required to center the needle. Left for "-" and right for "+" corrections.
8. Turn the Large knob to move to the Name selection. This value if for recording the name of the person
entering the values in the Test Log. Press the Cursor knob in to start editing. Turn the Small knob to
change the character. Turn the Large knob to the next character and turn the Small knob to change
the character. When editing is complete, press the Cursor knob again to exit editing the Name.
Basic Operation
Nav Radio
Nav Mode Test Log Information
51