ILS CDI
Switching the CDI from GPS to ILS for ILS approaches can be set to either Auto or manual. The Auto setting
allows the CDI output to automatically switch from the GPS receiver to the LOC receiver during ILS or LOC
approaches.
1. Turn the Large knob to highlight the ILS CDI selection.
2. Press the CRSR knob in to start editing.
3. Turn the Small knob to select AUTO or MANUAL.
4. Press the CRSR knob in again or press the Menu/Enter key to save the value.
Distance Units
This selection allows you to display distance information in units of nautical miles (nm), kilometers (km), or
statute miles (sm).
1. Turn the Large knob to highlight the Distance Units selection.
2. Press the CRSR knob in to start editing.
3. Turn the Small knob to change the value.
4. Press the CRSR knob in again or press the Menu/Enter key to save the value.
Altitude Units
This selection allows you to display altitude information in units of feet or meters.
1. Turn the Large knob to highlight the Altitude selection.
2. Press the CRSR knob in to start editing.
3. Turn the Small knob to change the value.
4. Press the CRSR knob in again or press the Menu/Enter key to save the value.
Basic Operation
System
ILS CDI Auto-Switching Setting
Distance Units
Selecting Altitude Units
113