Messages - Sony hcd-tb20 Operating Instructions Manual

Problems and remedies (continued)
If the system still does not operate
properly after performing the above
measures, reset the system as
follows:
1
Unplug the power cord.
2
Plug the power cord back into the wall
outlet.
3
Press ?/1 to turn on the system.
4
Press x, ?/1 and ENTER/YES at the
same time.
5
Unplug the power cord.
6
Plug the power cord back into the wall
outlet, then press ?/1 to turn on the
system.
The system is reset to the factory settings. All
the settings you made such as the preset
stations, clock, timer and CD disc titles are
cleared and must be set again.
Note
You cannot reset the system in the Power Saving
Mode.
GB
30
Downloaded From Disc-Player.com Sony Manuals

Messages

One of the following messages may appear or
flash in the display during operation.
CD
Cannot Edit
• You tried to label a CD TEXT disc.
• You tried to use Tape Select Edit for discs
containing over 20 tracks.
Name Full
There are already 50 disc titles stored in the
system.
No Disc
There is no CD in any of DISC 1 – 3.
NO STEP
You have cleared all the tracks you propgramed.
OVER
You have reached the end of the CD while
pressing M during play or pause.
Push STOP!
You pressed PLAY MODE/TUNING MODE
during play.
Step Full!
You tried to program 26 or more tracks (steps).
TAPE
No Tab
You cannot record the tape because the tab has
been removed from the cassette.
No Tape
There is no tape in the tape deck.
Open
You performed a tape operation with the tape deck
lid not completely shut.