Md Messages - Sony DHC-MDX10 Operating Instructions Manual

MD Messages
One of the following messages may appear or
flash in the display window during
operation.
Auto cut
The MD deck is pausing the recording
because silence continued for 30 seconds or
more during digital recording.
Blank Disc
The inserted recordable MD is new or atl
tracks on the MD have been erased.
Cannot edit
The inserted MD is a premastered MD.
You tried to edit in Programme or Shuffle
Play mode.
Cannot REC
Press FUNCTION to select the recording
source.
A pre-recorded MD is in the deck.
Complete ! !
MD editing was done completely.
Impossible
You tried to edit the track which you have
editted too many times.
You tried to divide the first or end of the
track.
Disc Full
There is no time remaining on the disc (see
"System Limitations of MDs" on page 84).
Eject
The MD deck is ejecting the disc.
No Disc
There is no MD in the deck.
Name Full
There is no more space to store track or
disc titles.
No Name
The inserted MD has a track numbers but
no disc titles.
- OVER -
You have reached the end of the last track
during high-speed search.
Position OK?
The dividing position playback while
dividing the MD track.
Push STOP!
You pressed PLAY MODE during play.
Standby (flashing)
If the timer was set but not used for a long
time, the contents of the seting are erased,
and cannot be recalled. Similarly, if a
program was entered and not used for a
long time, the program contents are erased
and the program cannot be played back.
Rehearsal
The dividing position playback after
designated it.
Smart Space
The signal was input again after silence
continued for 30 seconds or less during
digital recording.
TOC Reading
The MD deck is reading the TOC
information of the MD.
TOC Writing
The MD deck is writing the information of
recorded or edited contents.
Track End
You have reached the end of the track
while adjusting the division point during
Divide Function.
w_
o
89