Moorage - Honda BF250A Owner's Manual

OPERATION

Moorage

Tilt up the outboard motor using the
tilt lock lever when mooring the boat.
Shift the control lever into the
NEUTRAL position and stop the
engine before tilting up the outboard
motor.
Before tilting up, leave the outboard
motor in the running position for one
minute after stopping the engine to
drain the water from inside the
engine.
Stop the engine and disconnect the
fuel line from the outboard motor
before tilting the outboard motor.
66
TILT LOCK LEVER
FREE
LOCK
STERN BRACKET
1. Raise the outboard motor as full as
it goes using the power trim/tilt
switch.
2. Move the tilt lock lever to the
LOCK position and lower the
outboard motor until the lock lever
contacts the stern bracket.
3. Press the DN (down) of the power
trim/tilt switch and fully shorten
the trim rods.
4. To tilt down, raise the outboard
motor slightly, move the tilt lock
lever to the FREE position.
After tilting down the outboard
motors, adjust the trim angle of the
right and left outboard motors.
POWER TRIM/TILT SWITCH
TRIM RODS