Honda BF250A Owner's Manual page 93

MAINTENANCE
<Inspection>
FUEL FILTER
(inside strainer cup)
1. Remove the engine cover (see page
40).
2. Looking through the translucent
strainer cup, check the fuel filter
for water accumulation and
clogging.
If the fuel filter is clogged, refer to
page 93 to remove the filter and
clean it.
92
If a water is remained in the fuel
filter, refer to page 93 to remove the
strainer cup and empty the water from
the inside of the cup. Then drain the
water by following procedure.
CLAMP DRAIN TUBE
DRAIN SCREW
UNDER COVER
1. Remove the drain tube held by the
clamp on the left cylinder head
cover, and move the tip of the drain
tube which is inside of the under
cover to the outside.
2. Loosen the drain screw with the
flat tip screwdriver provided in the
tool kit.
3. Send the fuel by using the primer
bulb (see page 48).
4. Once the water has drained out of
the drain tube and gasoline starts to
flow out of the drain tube, stop
pushing the primer bulb. (Five
times may be required to drain the
water.)
Store the gasoline in a suitable
container.
5. When the gasoline flowing is
stopped, tighten the drain screw,
and hold the drain tube by the
clamp on the cylinder head cover.
6. Check there is no fuel leakage from
drain cock while sending the fuel
by using the priming pump.