Section 4 Adc 2100 And Dc 2200 Controllers; Introduction - Kohler 8.5RES Service

4.1 Introduction

This section
adjustment, and replacement of the ADC 2100 and
DC 2200 controller. See Section 3 for troubleshooting
procedures.
See Figure 4-1 for the locations of the controller and
related components.
controller keypad and display. Section 4.3 describes the
sequence of operation and faults are described in
Section 4.4. Controller configuration and adjustment
are covered in Section 4.5.
8
6
1. Controller
2. SCR module
3. Ground stud
4. L0 stud
Figure 4-1 Advanced Digital Control (ADC 2100)
TP-6196 10/09
Downloaded from www.Manualslib.com

Section 4 ADC 2100 and DC 2200 Controllers

covers operation, configuration,
Section 4.2 describes the
1
manuals search engine
A silicon controlled rectifier (SCR) module works with
the controller to regulate the output voltage.
Section 6.8.
A relay interface board (RIB) is used with the ADC
controller.
optional RIBs.
1
2
3
4
1 5
7
6
5. Relay interface board (RIB)
6. Line circuit breaker (load connection)
7. Engine harness-to-controller connection
8. Generator set master switch
Section 4 ADC 2100 and DC 2200 Controllers
Section 4.8 describes the standard and
See
GM29253
35