Kohler 8.5RES Service page 43

Pressing the up arrow key at the Adnc display (See Figure 4-8) puts you into
the Advanced Configuration Mode.
Press:
or
or
or
Note: Be sure to save your settings before exiting the configuration mode. The controller reverts to Note: Be sure to save your settings before exiting the configuration mode. The controller reverts to
the last saved settings when the master switch is moved to the OFF/RESET position. the last saved settings when the master switch is moved to the OFF/RESET position.
Figure 4-9 Advanced Configuration Mode (engine data input types, battery voltage, and engine
communications)
There are 3 options when the display says SAVE:
Press:
or
or
Now move the master switch to OFF/RESET.
* X in the runtime hours display above denotes any number from 0 to 9.
Figure 4-10 Save Mode (after configuring generator set parameters)
TP-6196 10/09
Downloaded from www.Manualslib.com
To set the engine data input type to Ed05.
To enter battery voltage selection mode.
To toggle between 12 and 24 VDC. Set this
parameter to 12 VDC.
To enter communications selection mode.
To set the communications parameter to
Cn00.
To enter SAVE mode. Go to Figure 4-10.
To return to the first parameter, system voltage/frequency
Uu, to check or change settings before saving. See
Figure 4-8.
To save changes.
To discard changes without saving.
Yes or no flashes when the up or down arrow is pressed
and then the controller exits the configuration mode. The
display returns to the runtime hours. *
manuals search engine
E d 0 5
B t 1 2
C n 0 0
S A V E
S A V E
U u 0 1
Y E S
n o
x x x x
Section 4 ADC 2100 and DC 2200 Controllers 43