Starting Up; Converting To Ipl - Intermec EasyCoder F4 Installation & Operation Manual

Ipl version bar code label printer

Hide thumbs Also See for EasyCoder F4:

Table of Contents

Chapter 3

Starting Up

Note: The same IPL ﬁ rmware

card can be used to convert for

than one printer.

To convert the printer from Fingerprint to IPL, proceed as follows:

• Make sure that the power is off by checking the "Power" control

lamp on the printer' s front panel. If not, switch off the power by

means of the On/Off switch on the rear plate.

• Insert the IPL ﬁ rmware card into the slot in the printer's rear

plate so the manufacturer's label faces right when view the

card as illustrated below.

• Switch on the power

• Wait until the following message appears in the display window

on the printer's front panel:

IPL-F2/4 V 1.00

READY

• Switch off the power and remove the card.

Intermec EasyCoder F4 – Installation & Operation IPL Version, Ed. 1

On/Off Switch

IPL-3 Firm-

ware Card

Table of Contents

Do you have a question about the EasyCoder F4 and is the answer not in the manual?