Using The Unit Safely; Important Notes - Roland VR-6HD Startup Manual

USING THE UNIT SAFELY

WARNING
Concerning the Auto Off function
The power to this unit will be turned off automatically
after a predetermined amount of time has passed since
it was last used buttons or controls were operated
(Auto Off function).
For details, refer to "Reference Manual" (PDF).
Secure a sufficient amount of space at the setup location
Since this unit normally emits a slight amount of heat,
make sure to secure sufficient space around it, as
shown below.
Rear
30 cm (12 in.)
5 cm (2 in.) or
or greater
greater
20 cm (8 in.) or greater 20 cm (8 in.) or greater
Use only the supplied AC adaptor and the correct voltage
Be sure to use only the AC adaptor supplied with the
unit. Also, make sure the line voltage at the installation
matches the input voltage specified on the AC
adaptor's body. Other AC adaptors may use a different
polarity, or be designed for a different voltage, so their use
could result in damage, malfunction, or electric shock.

IMPORTANT NOTES

Power Supply
¹ Place the AC adaptor so the side with the indicator faces
upwards. The indicator will light when you plug the AC
adaptor into an AC outlet.
Placement
¹ Depending on the material and temperature of the surface
on which you place the unit, its rubber feet may discolor or
mar the surface.
Repairs and Data
¹ Before sending the unit away for repairs, be sure to make
a backup of the data stored within it; or you may prefer to
write down the needed information. Although we will do
our utmost to preserve the data stored in your unit when we
carry out repairs, in some cases, such as when the memory
section is physically damaged, restoration of the stored
content may be impossible. Roland assumes no liability
concerning the restoration of any stored content that has
been lost.
Additional Precautions
¹ Any data stored within the unit can be lost as the result
of equipment failure, incorrect operation, etc. To protect
yourself against the irretrievable loss of data, be sure to make
a backup of the data stored within it; or you may prefer to
write down the needed information.
¹ Roland assumes no liability concerning the restoration of any
stored content that has been lost.
¹ Never strike or apply strong pressure to the display.
¹ This unit allows you to switch images at high speed. For some
people, viewing such images can cause headache, nausea,
or other discomfort. Do not use this unit to create video
that might cause these types of health problems. Roland
Corporation will accept no responsibility for any such health
problems that may occur in yourself or in viewers.
¹ Do not use connection cables that contain a built-in resistor.
Use only the supplied power cord
Use only the attached power cord. Also, the supplied
power cord must not be used with any other device.
Handle lithium batteries carefully
¹ Lithium batteries must never be recharged, heated,
taken apart, or thrown into a fire or water.
¹ When replacing lithium batteries, make sure that
you put them in a place where children cannot
reach or touch them.
Side
¹ Keep lithium batteries out of reach of small
children.
¹ In the event that someone accidentally swallows
15 cm (6 in.) or
a lithium battery, this could cause serious or life-
greater
threatening problems within a matter of two hours.
Contact a doctor at once.
¹ Never expose lithium batteries to excessive heat
such as sunshine, fire or the like.
Using External Memories
¹ Please observe the following precautions when handling
external memory devices. Also, make sure to carefully
observe all the precautions that were supplied with the
external memory device.
– Do not remove the device while reading/writing is in
progress.
– To prevent damage from static electricity, discharge all
static electricity from your person before handling the
device.
Caution Regarding Radio Frequency Emissions
¹ The following actions may subject you to penalty of law.
– Disassembling or modifying this device.
– Removing the certification label affixed to the back of
this device.
– Using this device in a country other than where it was
purchased
¹ This unit cannot be used to directly connect to a network
operated by a telecommunications provider (such as a mobile
or landline-based telecommunications company, an Internet
provider or the likes), including a public wireless LAN. You
must use a router or similar equipment when connecting this
unit to the Internet.
WARNING CAUTION
Handle the ground terminal carefully
If you remove the screw from the ground terminal, be
sure to replace it; don't leave it lying around where
it could accidentally be swallowed by small children.
When refastening the screw, make that it is firmly
fastened, so it won't come loose.
Take care not to get burned
The bottom of unit may become hot, so take care to
avoid burns.
Precautions concerning use of phantom power supply
Always turn the phantom power off when connecting
any device other than condenser microphones that
require phantom power. You risk causing damage if
you mistakenly supply phantom power to dynamic
microphones, audio playback devices, or other devices that
don't require such power. Be sure to check the specifications of
any microphone you intend to use by referring to the manual
that came with it.
(This instrument's phantom power: 48 V DC, 14 mA Max)
Intellectual Property Right
¹ It is forbidden by law to make an audio recording, video
recording, copy or revision of a third party's copyrighted work
(musical work, video work, broadcast, live performance, or
other work), whether in whole or in part, and distribute, sell,
lease, perform or broadcast it without the permission of the
copyright owner.
¹ Do not use this product for purposes that could infringe on a
copyright held by a third party. We assume no responsibility
whatsoever with regard to any infringements of third-party
copyrights arising through your use of this product.
¹ This product can be used to record or duplicate audio or
visual material without being limited by certain technological
copy-protection measures. This is due to the fact that this
product is intended to be used for the purpose of producing
original music or video material, and is therefore designed
so that material that does not infringe copyrights belonging
to others (for example, your own original works) can be
recorded or duplicated freely.
¹ The SD logo
, SDHC logo and SDXC logo
are trademarks of SD-3C, LLC.
¹ This product is using the open source license (GPL/LGPL)
software. You have the right to acquire, modify and distribute
the source code for this open source license software. You
can obtain the open source license source code used in this
product by downloading it from the following website:
https://proav.roland.com/global/support/
¹ This product contains eParts integrated software platform of
eSOL Co.,Ltd. eParts is a trademark of eSOL Co., Ltd. in Japan.
¹ The Bluetooth® word mark and logos are registered
trademarks owned by Bluetooth SIG, Inc. and any use of such
marks by Roland is under license.
¹ Roland is an either registered trademark or trademark
of Roland Corporation in the United States and/or other
countries.
¹ Company names and product names appearing in this
document are registered trademarks or trademarks of their
respective owners.
7