Installing The Tabletop Tape; Drive With A Usb Connector - Quantum STD2401LW Installation Instructions Manual

Figure 2 SCSI Termination
Examples of the External Tape
Drive
Figure 3 SCSI Termination
Examples of the External Tape
Drive
External tape drive
External SCSI device
SCSI controller
(termination enabled)
Example 1: SCSI termination in a
system that has only external SCSI devices.
Installing a Tabletop Tape
Drive with a USB
Connector
68-pin wide SCSI
connectors
5 Check the SCSI termination.
SCSI terminator
6 Connect a power cable to the AC power connector on the back of the tape drive.
Connect the other end of the power cable to a working AC outlet.
7 Turn on the computer, turn on the tape drive, and verify that the tape drive is
operating properly.
8 Register your tape drive at http://www.quantum.com/registration.
To install the tabletop tape drive with a USB connector:
1 Unpack the contents of your drive package. If any item is damaged, please contact
0
your place of purchase immediately.
SCSI ID selector
Example 2: SCSI termination in a system
that has both internal and external SCSI devices.
Table Tape Drive
DDS-4/DAT 72
SCSI device
(termination
enabled)
External tape drive
SCSI controller
(termination disabled)
Internal SCSI device
(termination enabled)
3