Page 2
How to operate the Audionet AMP I The Audionet AMP I is an audio power amplifier of highest performance and finish quality and long-life stability. This system is designed for ab- solute natural music reproduction. The following will give you all information about how to operate your AMP I.
The AMP I has two RCA inputs for the connection of a preamplifier, e.g. Audionet PRE. Due to the dual mono construction, left and right inputs are separated at the rear. Please connect left and right input of the AMP I to the corresponding outputs of your preamplifier.
Page 4
AMP I can be switch on and off by the preamplifier. Please connect the Audionet-link output of the preamplifier with a Toslink optical fibre ca- ble to the Audionet-link input of the AMP I. The power switch at the front must be in „off“ position.
Page 5
Now the music stops. Note To enable „remote controlling“ by Audionet-link, after switching off the AMP I is always in stand-by state with low power consumption. Only in case of longer absence the AMP I should be disconnected from the power supply (mains unplugged).
Technical information Construction The AMP I is constructed as a dual-mono amplifier. SMD techniques are used to optimise high-frequency characteristics. All signal paths are re- duced to minimum length. No ‘evil’ elements (coupling capacitors, coils, relays) are located in the signal path. The construction is magnetically and capacitively optimised.
Security advice ¨ Avoid packaging material, especially plastic bags, to come into children’s hands. ¨ Store and operate the unit in a dry room at a reasonable room temperature. ¨ Avoid moisture or any liquid to get into the unit. ¨...
1500 W dimensions 430 mm * 185 mm * 315 mm (w * h * d) weight 28 kg Subject to modification Engineered und produced by: Idektron GmbH & Co. KG, Herner Str. 299, Gebäude 6, 44809 Bochum www.audionet.de contact@audionet.de...
Need help?
Do you have a question about the AMP 1 and is the answer not in the manual?
Questions and answers