Ormed Artromot S3 Operating Instructions Manual page 75

12. Only use the original shipping box
for transporting the device. Ormed
GmbH & Co. KG cannot be held
liable for transport damage, if the
device was not shipped in its
original shipping box.
13. Place the ARTROMOT
down – on the bottom of the box.
The markings on the bottom of the
box indicate the correct position.
14. Then put the enclosed polystyrene
block on the chair, observing the
cut-outs in the block.
15. Put the programming unit (1) in the
supplied box. Place the motion
element, the armrest, the compo-
nents of the neck and shoulder
restraint and the power cord in the
respective cut-outs in the poly-
styrene block.
®
-S3 – legs
16. Then close the box.
Reverse the above steps to reassemble
the device after transport.
Shock hazard – Before use allow the
ARTROMOT
temperature. If the device has been
transported at temperatures below
0 °C (32 °F), leave it to dry at room
temperature for about 2 hours, until
any condensation has disappeared.
75
Warning!
®
-S3 to reach room