Switch Housing - Hunter M3571-01 Instruction Manual

Table of Contents

Advertisement

Switch Housing

Note: Remove the shipping
ring before installing the
switch housing. See page 6
Screw two housing assembly screws
from the
hardware bag halfway into
the motor housing. It does not matter
which two screw holes you choose.
for more details.
Feed the 9-pin wire plug through the
center hole of the upper switch housing,
then wrap keyhole slots around the
screws and twist counterclockwise.
M3571-01 • 06/29/16 • © 2016 Hunter Fan Company
14
www.HunterFan.com
Insert the third screw, found in
the
hardware bag, into place and
tighten all three screws securely.
Make sure the upper switch housing is securely
attached to the mounting plate. Failure to properly
secure all three assembly screws could result in the
switch housing fixture falling.
1.888.830.1326

Advertisement

Table of Contents
loading

Table of Contents