Table of Contents
Advertisement
Wiring
Receiver
Place the receiver on top of the downrod
assembly as shown.
Tip: If you have difficulty fitting the receiver
into place, make sure you have cut the excess
wires from the fan. See page 8 for more details.
Refer to CAUTION c.1 on pg. 2
Note: To connect the wires, hold
the bare metal leads together and
place a wire connector over them,
then twist clockwise until tight.
Using an orange wire connector
from the
hardware bag:
Connect the 3 grounding wires
(green, green/yellow stripe, or bare
copper) coming from the ceiling,
downrod, and ceiling bracket.
into the outlet box. Spread the wires apart, with the grounded wires on one side of
10
M3571-01 • 06/29/16 • © 2016 Hunter Fan Company
www.HunterFan.com
green/yellow stripe
Turn the splices upward and push them carefully back through the hanger bracket
the outlet box and the ungrounded wires on the other side of the outlet box.
1.888.830.1326
Advertisement
Table of Contents
