Shinybow USA SB-3877 User Manual

SAFETY INFORMATION

1. Save the carton and packing material even if the equipment has arrived in good condition. Should you ever need to ship the unit, use only the original
factory packing.
2. Read all documentation before operating your equipment. Retain all documentation for future reference.
3. Follow all instructions printed on unit chassis for proper operation.
4. Do not spill water or other liquids into or on the unit, or operate the unit while standing in liquid.
5. Make sure power outlets conform to the power requirements listed on the back of the unit.
6. Do not use the unit if the electrical power cord is frayed or broken. The power supply cords should be routed so that they are not likely to be walked on
or pinched by items placed upon or against them, paying particular attention to cords and plugs, convenience receptacles, and the point where they exit
from the appliance.
7. Always operate the unit with the AC ground wire connected to the electrical system ground. Precautions should be taken so that the means of grounding of
a piece of equipment is not defeated.
8. Mains voltage must be correct and the same as that printed on the rear of the unit. Damage caused by connection to improper AC voltage is not covered by
any warranty.
9. Power down & disconnect unit from mains voltage before making connections.
＂
10. Never hold a power switch in the "ON position.
11. Do not use the unit near stoves, heat registers, radiators, or other heat Producing devices.
12. Do not block fan intake or exhaust ports. Do not operate equipment on a surface or in an environment which may impede the normal
such as a bed, rug, carpet, or completely enclosed rack. If the unit is used in an extremely dusty or smoky environment, the unit should be
periodically "blown free" of foreign matter.
13. Do not remove the cover. Removing the cover will expose you to potentially dangerous voltages. There are no user serviceable parts inside.
14. Do not drive the inputs with a signal level greater than that required to drive equipment to full output.
Non-use periods. The power cord of equipment should be unplugged from the outlet when left unused for a long period of time.
15.
16. Service Information Equipment should be serviced by qualifier service personnel when:
A. The power supply cord or the plug has been damaged.
B. Objects have fallen, or liquid has been spilled into the equipment.
C. The equipment has been exposed to rain
D. The equipment does not appear to operate normally, or exhibits a marked change in performance
E. The equipment has been dropped, or the enclosure damaged.
www.shinybowusa.com
THIS SAFETY INFORMATION IS OF A GENERAL NATURE AND MAY BE SUPERSEDED BY INSTRUCTIONS CONTAINED WITHIN THIS MANUAL
VIDEO/AUDIO INPUTS
VIDEO/AUDIO OUTPUTS
AUTO DETECTION TV VIDEO SYSTEM
OSD MENU SELECTIONS
VIDEO BANDWIDTH
flow of air around the unit,
AUDIO BANDWIDTH
AUDIO FREQUENCY RESPOND
INPUT SOURCE RESOLUTIONS
UNIT OUTPUT RESOLUTIONS
CONTROL
RS-232 CONTROL
SAFETY APPROVALS
DIMENSIONS (LWH)
POWER SUPPLY
SHIPPING WEIGHT
As product improvements are continuous, specifications are subject to change and
without notice.
SB-3877 INSTRUCTION & OPERATION MANUAL
- 2x HDMI (Digital Video-TMDS & Digital Audio-PCM) via HDMI connectors
- 2x CVBS/S-Video(Y/C)/Audio Via Composite(1x RCA), S-Video(1x min din-4p) & Stereo Audio(2xRCA)
- 2x Component Video(YP P )/Audio Via Component(3x RCA) & Stereo Audio(2xRCA)
B R
- 2x VGA(RGBHV) / Audio Via VGA(2x HD-15P) & Stereo Audio(2xRCA)
- 2x HDMI (Digital Video-TMDS & Digital Audio-PCM) via HDMI connectors
- 2x Digital Audio Via 2x RCA
- 2x VGA(RGBHV) / Audio Via VGA(2x HD-15P) & Stereo Audio(2xRCA)
NTSC-M 3.58, NTSC-J, 4.43, PAL-B-D-I-G-H-K, PAL-M, PAL-N, PAL-N COMB-N, SECAM (Impedance:75 ohms)
Adjust Color : Contrast, Brightness, Sharpness, Level and Gain
- HDMI for 480p, 720p & 1080p
- Component Video (YP P ) for 480p, 720p & 1080p
B R
- VGA for VGA(640x480), SVGA(800x600), XGA(1024x768), SXGA(1280x1024) Maximum
- HDMI for 720p & 1080p
- VGA for SVGA (800x600), XGA (1024x768), SXGA (1280x1024), WXGA (1366x768)
WXGA+ (1680x1050), WUXGA (1920x1200) Maximum
Direct Front Panel menu, Remote control & RS-232/RS-485
19 x 7.87 x 1.75 (482mm x 200mm x 44mm) "
12VDC, 3A (2.45A Max.) Universal Switch type 50/60Hz 100~230 VAC

SPECIFICATIONS

8x VIDEO INPUTS
2x VIDEO OUTPUTS
250MHz, (-3 d B)
>60MHz, (-3 d B)
20Hz ~ 20KHz
9600 bps, No Parity, 8 bits, 1 Stop bit
CE, FCC, RoHS(2002/95/EC)
" "
3.5KGS
PAGE 11