HAKO Scrubmaster B310 R Instruction Manual page 22

Hide thumbs Also See for Scrubmaster B310 R:
Table of Contents

Advertisement

Starting Up
5. Force the narrow end of the
assembly tool (Fig. 7/1) downwards.
As a result of the levering effect, the
brush (Fig. 7/2) or pad (Fig. 7/5) is
pressed into the brush catch and
audibly latches in place.
6. In order to control whether all the
hooks are in place, turn the brush or
pad installed once.
7. Continue by assembling the outer
brushes, refer to
Section "Assembling the outer
brushes / pads".
8. Close the deflector, refer to
Section "Opening and closing the
deflector". The deflector (Fig. 5/1) is
now in its working position.
Assembling the outer
brushes / pads
1. Open the deflector (Fig. 5/1), refer to
Section "Opening and closing the
deflector".
2. Slide the brush (Fig. 7/2) or pad
(Fig. 7/5) under the brush head in
accordance with Fig. 8.
3. Raise the brush (Fig. 7/2) or pad
(Fig. 7/5) and turn it slightly until the
toothing meshes.
22
1
Fig. 8
4. Pull the brush (Fig. 7/2) or pad
(Fig. 7/5) up until all six hooks latch
in the catches.
5. In order to control whether all the
hooks are in place, turn the brush or
pad installed once.
6. Close the deflector, refer to
Section "Opening and closing the
deflector". The deflector (Fig. 5/1) is
now in its working position.
You can also use the assembly
tool as an aid to complete
steps 2 to 4, refer to the
corresponding steps 3 to 5 in
Section "Assembling the
middle brush or middle pad". 
When completing Step 5, pay
attention that you must
simultaneously use your free
hand to push down on the
brush head! Exerting
counterpressure is the only
way to ensure that the brush or
pad engages properly!
Disassembling the outer
brushes / pads
1. Open the deflector (Fig. 5/1), refer to
Section "Opening and closing the
deflector".
2. Pull the brush (Fig. 7/2) or pad
(Fig. 7/5) from the brush head. Or:
3. Slide the narrow side of the
assembly tool between the
brush/pad and brush head and press
the wide end of the assembly tool
downwards. As a result of the
levering effect, the brushes / pads
are released from the brush head
(Fig. 7/3).

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents