Thecus N2810 User Manual page 36

Start IP (IPv4)
End IP in (IPv4)
Default Gateway (IPv4)
DNS Server 1,2,3 (IPv4)
Prefix (IPv6)
Prefix Length (IPv6)
WARNING
VLAN:
Each NIC is capable of VLAN support. To enable VLAN, simply click the check box
and input the VLAN ID (VLAN ID can be any digital number). The system with the
same VLAN ID will become a Virtual LAN group to allow more specific
communication among members.
Host Setting:
Other than setup each network port, there is global setting required.
Network Configuration (Global parameter)
Item
Host name
Domain name
WINS Server
DNS Mode
DNS Server 1,2,3
Default Gateway
IP Share Mode
Specifies the lower IP address of the DHCP range.
Specifies the highest IP address of the DHCP range.
Specifies gateway for the DHCP server service.
Displayed the DNS server IP address.
Specifies prefix
Specifies prefix length
The IP address of associated NIC should not be in the range of the Start IP
address and End IP address (IPv4).
Description
Host name that identifies the Thecus IP storage on the network.
Specifies the domain name of Thecus IP storage.
To set a server name for NetBIOS computer.
Select the DNS server is coming from DHCP server or manual input.
A total of 3 DNS servers can be input. If the DNS setting is chosen
from DHCP server, then it will refer to WAN/LAN1 port.
Domain Name Service (DNS) server IP address.
It can be chosen from a drop down list of default gateway that's been used
for the Thecus IP storage.
When client PCs has connected to the LAN port with DHCP server function
enabled other than WAN/LAN1 and it will be able to access Internet through
WAN/LAN1 while WAN/LAN1 has direct connect to ADSL/Cable device.
36