Brother MFC-8460N Servise Manual page 409

- Selectors 1 through 3: Redial/Pause key setting and 2nd dial tone detection
Selectors
1 2 3
0 0 0 No WAIT is inserted even if the [Redial/Pause] key is pressed.
0 0 1 If you press the [Redial/Pause] key during dialing, the machine will insert
0 1 0 WAIT as defined in the above table.
0 1 1
If the [Redial/Pause] key is pressed repeatedly, the machine inserts the
1 0 0
specified WAIT multiplied by the number of depressions. It applies also in
hook-up dialing.
1 0 1 When these selectors are set to "1, 0, 1":
1 1 0
Each time you press the [Redial/Pause] key in dialing, the machine will wait
1 1 1
for the 2nd dial tone to be sent via the communications line regardless of
pulse dialing or tone dialing.
When these selectors are set to "1, 1, 0":
If you press the [Redial/Pause] key in pulse dialing, the machine will first
wait for the 2nd dial tone to be sent via the communications line. After that,
pressing the [Redial/Pause] key will cause the machine to insert a WAIT of
3.5 seconds. In tone dialing, the machine will insert a WAIT of 3.5 seconds.
When these selectors are set to "1, 1, 1":
If you press the [Redial/Pause] key, the machine will first wait for the 2nd
dial tone to be sent via the communications line regardless of pulse dialing or
tone dialing. After that, pressing the [Redial/Pause] key will cause the
machine to insert a WAIT of 3.5 seconds.
(In those countries where no dial tone detection function is supported, setting
these selectors to "1, 0, 1," "1, 1, 0," or "1, 1, 1" inserts a WAIT of 3.5
seconds.)
- Selectors 4 through 6: Detection of international tone
Upon detection of the 2nd dial tone for the time length specified by these selectors, the machine
starts dialing.
This setting is effective only when the 2nd dial tone detection function is activated by selectors 1
through 3 (Setting 101, 110, or 111).
This function does not apply in those countries where no dial tone detection function is supported.
- Selector 7: No. of 2nd dial tone detection cycles
This selector sets the number of dial tone detection cycles required for starting dialing.
- Selector 8: Allowable instantaneous interrupt during reception of 2nd dial tone
This selector sets the allowable instantaneous interrupt period that should be ignored during
reception of the 2nd dial tone.
App. 4-10 Confidential