Setting Up The Controller - Daikin BRC1D71 Operation Manual

30 SCHEDULE TIMER BUTTON
This button enables or disables the schedule timer.
31 TIME ADJUST BUTTON
These buttons are used to adjust the clock or, when in
programming mode, to adjust the programmed action
time. Both buttons have an auto-repeat function.
32 TEMPERATURE ADJUST BUTTONS
These buttons are used to adjust the current setpoint
or, when in programming mode, to adjust the
programmed setpoint temperature (step = 1°F). Both
buttons are also used to adjust the day of the week.
33 OPERATION CHANGE/
This button is a multi-purpose button. Depending on
the previous manipulations of the user, it can have
following functions:
1 select the operation mode of the installation
(FAN, DRY, AUTOMATIC, COOLING, HEATING)
2 toggle between minimum temperature and
maximum temperature when in limit operation
34 SETPOINT/LIMIT BUTTON
This button toggles between setpoint, limit operation
or (programming mode only).
35 FAN SPEED BUTTON
This button toggles between L (Low), H (High), HH
(very High), AUTO (Automatic).
36 AIR FLOW DIRECTION ADJUST BUTTON
This button enables to adjust the air flow direction.
Operation manual
5
37 AIR FILTER CLEANING TIME ICON RESET
BUTTON
This button is used to reset the air filter cleaning time
icon.

3. Setting up the controller

After initial installation, the user can set the clock and
day of the week.
The controller is equipped with a schedule timer that
enables
automatically; setting the clock and day of the week is
required to be able to use the schedule timer.
1 CLOCK SETTING FUNCTION
BUTTON
Hold down the SCHEDULE button for 5 seconds. The
clock read-out and the day of week indicator will blink,
both can now be adjusted.
Use the TIME
adjust the clock. Each time pressing the time adjust
button will in/decrease the time by 1 minute. Keeping
the TIME
in/decrease the time by 10 minutes.
Use the TEMP
adjust the day of the week. Each time pressing the
TEMP
the next or previous day.
Press the FUNCTION button to confirm the current
set time and day of the week.
If the controller, with blinking clock and day of week
read-out, is left untouched for 5 minutes, the clock
and day of the week will return to their previous
settings; the clock setting function is no longer active.
2 SETTING UP THE SCHEDULE TIMER
To set up the schedule timer, refer to chapter 6.
"Programming the schedule timer" on page 11.
the user to operate
& TIME
or TIME button pressed will
& TEMP
or TEMP buttons will display
the installation
buttons to
buttons to
BRC1D71
Remote controller
3P166742-1