Troubleshooting - Daikin BRC1D71 Operation Manual

3 I WANT TO DELETE ONE OR MORE
PROGRAMMED ACTIONS
Make sure you are not in program mode (
blinking); if required, press SCHEDULE to quit
program mode.
Browse to the programmed actions using the
FUNCTION button, select the day you want to edit.
Press the FUNCTION button for 5 seconds; program
mode is enabled, the
blinking.
Select the "last action" you want to keep using the
FUNCTION button. All higher actions will be deleted.
Confirm the deletion by pressing the FUNCTION
button for 5 seconds,
OR
confirm the deletion for the current and the next day
too by pressing the FUNCTION and SETBACK
buttons simultaneously for 5 seconds.
NOTE In the case above, if for example the last
action was 3, the programmed actions 4
and 5 will also be deleted (if they were
present).
4 I WANT TO DELETE ALL PROGRAMMED
ACTIONS AT ONCE
Quit programming or browsing.
Press the FUNCTION
simultaneously for 5 seconds; the
and disappear to confirm deletion.
7. Maintenance
The remote controller does not need maintenance.
Remove dirt with a soft damp cloth.
NOTE Only use clear tepid water to moisten the
cloth.
BRC1D71
Remote controller
3P166742-1
icon and selected action are
and buttons
icon will invert

8. Troubleshooting

The guidelines below might help to solve your
not
problem. If you cannot remedy the problem, consult
your installer.
No readings on the remote controller (display
blank)
Check if the mains power is still applied to your
installation.
Only is displayed
This indicates that the installation has just been
powered, please wait until
The schedule timer does work but the
programmed actions are executed at the wrong
time (e.g. 1 hour too late or too early)
Check if the clock and the day of the week are set
correctly, correct if necessary (refer to "CLOCK
SETTING FUNCTION" on page 5).
I cannot enable the schedule timer (the
blinks for 2 seconds and disappears)
The schedule timer has not been programmed yet.
First program
"Programming the schedule timer" on page 11).
I cannot enable the schedule timer (the
icon is displayed)
The schedule timer can not be enabled when a
centralised control is connected.
Limit operation cannot be selected
Limit operation is not available for cooling only
installations.
disappears.
the schedule timer
Operation manual
icon
(refer to
14