Daikin BRC1D71 Operation Manual page 16

Programming
1 THE SCHEDULE TIMER IS PROGRAMMED
FOR THE FIRST TIME
NOTE When changing day during programming
you will have to confirm "the last action".
Each day can have 5 programmed
actions (numbered 1 to 5) but for some
reason you might want to delete one,
several or all programmed actions.
To be able to delete programmed actions,
you must select the last action that you
want to keep, this can be 1 to 5 or no
action ( is displayed and no action
displayed).
All programmed actions with a number
HIGHER than the selected one, or all
programmed actions if no last action was
selected will be deleted.
PROGRAMMING THE FIRST DAY OF THE WEEK
NOTE In the guidelines below it is assumed that
you start programming the schedule
timer actions on Monday and end with the
schedule timer actions for Sunday.
If you prefer NOT to start on Monday, first
browse to the desired day and then enter
the PROGRAM mode.
BRC1D71
Remote controller
3P166742-1
In this particular case, no actions have been program-
med before, all schedule timer actions are idle.
• Browse to Monday by pressing the FUNCTION
button. The icon appears,
one of the
displayed but all other fields remain blank,
indicating that no actions are programmed for
Monday.
• Enter the program mode by holding down the
FUNCTION button for 5 seconds, the
will now blink too.
• Press the FUNCTION button to activate the
first programmed action.
• A blinking is displayed indicating that the first
programmed action for Monday is being
programmed; The set temperature and clock
display are blinking.
• Press the SETBACK button to select either set
temperature,
• Enter the desired temperature using the
TEMP & TEMP
• Press the button to toggle between
minimum set temperature and maximum set
temperature in limit operation, the selected
temperature will blink.
• Enter the time when the action must start
using the TIME
(min. step = 10 minutes).
NOTE
If, by accident,
FUNCTION button, you activated the next
action; is displayed ( steady and
blinking). Press the FUNCTION button
repeatedly until a blinking
You can now continue adjusting the
settings for the first schedule timer action.
will blink and
icons might be
icon
, or limit operation.
buttons.
& TIME buttons
you pressed the
is displayed.
Operation manual
12