Using The Mower; Cable Holder - Stiga Turbo 55 COMBI Instructions For Use Manual

GB
INSTALLATION
LOOSE PARTS IN THE BOX
2 brackets for the grass collector
4 screws for the brackets
1 ignition key (*)
1 battery charger (*)
1 Allen key
1 socket wrench
+ Instruction books
HANDLE
(Type I-III)
1. Fold up the lower part of the handle.
2. Install the upper part of the handle mounts using
screws, washers and locking wheels. A lug is
installed on the right hand side for the starter
handle (fig. 1).
3. Then tighten the locking wheels onto the lower
part of the handle. When these have been tight-
ened, the height of the handle can be adjusted by
tightening the screws B with the wrench provid-
ed. (fig. 2)
HANDLE
(Type IV)
1. Unscrew the locking wheels from the chassis
and secure the lower part of the handle onto
screws B (fig. 3).
2. Secure the upper part of the handle with wash-
ers and locking wheels. There is a lug on the
right hand side for the starter handle (fig. 1).
3. Then tighten the locking wheels onto the lower
part of the handle. When these have been tight-
ened, the height of the handle can be adjusted
by tightening the screws B with the wrench pro-
vided. (fig. 3)
ENGINE BRAKE CABLE
Secure the engine brake cable to the engine brake
(fig. 4). Note that the cable should be installed in
the direction of the handle.

CABLE HOLDER

Secure the cables in the cable holders (fig. 5):
D: Start/Stop cable + Clutch cable (*)
E: Throttle cable (*) + Clutch cable (*)
F: Electric cable (*) + Variator cable (*)
40
ENGLISH
VARIATOR CONTROL (*)
When the mower is delivered, the variator cable is
set so that the transmission cannot be damaged.
The cable may need tightening, see under heading
"ADJUSTING VARIATOR CABLE" in the sec-
tion "MAINTENANCE".
GRASS COLLECTOR
Raise the collector flap and attach the two brackets
to the grass collector with the screws provided.
The brackets are marked with L and R and should
be installed at the corresponding mark on the rear
of the mower (fig. 7).
Fabric grass collector (*): Fit the fabric bag over
the steel frame and then snap the bag onto the plas-
tic lid (fig. 6).
Plastic grass collector (*): Snap together both
halves and then the upper part (fig. 8).
Open the flap on the machine and attach the grass
collector to the brackets.
NOTE! The lawnmower can be operated without
the grass collector. The grass is then left in a line
behind the machine.
BATTERY (*)
The electrolyte in the battery is toxic
and corrosive. It can cause serious cor-
rosion damage etc. Avoid all contact
with skin, eyes and clothing.
Before starting for the first time the battery should
be charged for 24 hours, see further information
under the heading MAINTENANCE, BATTERY.
Insert ignition key (*) into the ignition lock.

USING THE MOWER

COMBI(*)
Your new lawnmower combines two different
functions in the same machine:
1. "MULTICLIP"
The machine comes equipped with a plug (P), in-
stalled in the ejector opening (fig. 31). The ma-
chine can be used for 'Multiclip' i.e. the blade
finely cuts up the grass during mowing. The grass
then falls into the lawn where it is allowed to rot.
This provides the lawn with nourishment.