Advertisement
Advertisement
Table of Contents
Related Manuals for Stiga 48 S ROLLER
Summary of Contents for Stiga 48 S ROLLER
- Page 1 S T I G A T U RB O 5 5 S R O L L E R 4 8 S R O L L E R 8211-0324-02...
- Page 2 SVENSKA...
- Page 3 Briggs & Stratton 0,15 l. Briggs & Stratton SVENSKA Honda FULL/MAX ADD/MIN...
- Page 4 Honda Briggs & Stratton XTE SVENSKA Honda GCV...
- Page 5 SVENSKA 40 Nm...
- Page 6 SYMBOLS The following symbols appear on the machine. They are there to remind you of the care and attention required in use. This is what the symbols mean: Warning! Read the Instruction Book and Safety Manual before using the machine. Warning! Keep onlookers away.
-
Page 7: Using The Mower
VARIATOR CONTROL When the mower is delivered, the variator cable is set so that the transmission cannot be damaged. The cable may need tightening, see under heading “ADJUSTING VARIATOR CABLE“ in the section “MAINTENANCE“. GRASS COLLECTOR Fit the fabric bag over the steel frame and then snap the bag onto the plastic lid (fig. -
Page 8: Starting The Engine (Honda)
5. Press the Start/Stop loopG towards the handle. NOTE! The Start/Stop loopG must be kept pressed in to prevent the engine stopping (fig. 16). 6a Manual start: Grasp the starter handle and start the engine by pulling briskly on the starter cord. 6b Electric start (*): Start the engine by turning the ignition key clockwise. -
Page 9: Maintenance
Do not set the cutting height so low that the blade comes into contact with uneven ground. The mower has single-lever control for adjusting the cutting height. Pull the lever out, and set the cutting height to one of the positions best suited to your lawn (fig. -
Page 10: Changing Blades
Change the spark plug if the electrodes are excessively burnt or if the plug is damaged. The engine manufacturers’ recommendations are as follows: Briggs & Stratton: Champion J19LM (RJ19LM), Spark gap 0.76 mm. Honda: NGK BPR6ES, Spark gap 0.7-0.8 mm. BATTERY (*) The electrolyte in the battery is toxic and corrosive. -
Page 11: Sharpening The Blades
To replace the blade, undo the screw (fig. 27). Fit the new blade so that the stamped logo is turned up facing the blade holder (not facing the grass). Reinstall as illustrated. Tighten the screw properly. Tightening torque 40 Nm. When replacing the blade, the blade screw should also be replaced. - Page 12 M O W I N G A H E A D G G P S w e d en A B · B ox 1 00 6 · S E- 5 73 28 T R A N Å S w w w. s t i g a . c o m...
Need help?
Do you have a question about the 48 S ROLLER and is the answer not in the manual?
Questions and answers