Nokia Customer Care
• Set AGC Mode to Algorithm.
• Set Channel to 10700.
• Set AFC Algorithm to OFF (Default = OFF).
Next action
When settings are ready, click Start to activate them.
If settings are changed later on (for example, you give a new channel number), you will need to click Stop
and Start again.
Note:
Clicking Stop also disables Tx Control if that was active!
WCDMA RSSI measurement
Before you begin
WCDMA Rx must be activated before RSSI can be measured. See
measurement (page
7–13).
Steps
Phoenix service software.
1. Start
2. Choose Testing→WCDMA→Rx Power Measurement .
Rx Power Measurement window, choose the following settings:
3. In the
• Mode: RSSI
• Continuous Mode
Page 7 –14
Rx Control window
Figure 58
COMPANY CONFIDENTIAL
Copyright © 2006 Nokia. All rights reserved.
RF Troubleshooting and Manual Tuning Guide
WCDMA Rx chain activation for manual
RM-91; RM-92
Issue 1