ATTO Technology iPBridge 2700C Installation And Operation Manual page 45

SNMPDumpMIB
Displays the contents of the ATTO iPBridge private
SNMP MIB to the current CLI session. For further
assistance with SNMP, consult your network
administrator.
SNMPDumpMIB
SNMPExtendedTraps
Regulates Extended (i.e., Device Transition and Device
Error) SNMP trap functionality.
Default: disabled
set SNMPExtendedTraps [enabled | disabled]
get SNMPExtendedTraps
SNMPTrapAddress
Regulates or displays IP Trap Addresses and Trap
Levels. Index is a value from 1 to 6. The IP address must
be in the same subnet as the iPBridge, and is the host that
wishes to receive traps. The supported severity levels
required to trigger a trap are: None, All, Warning,
Critical
Default: 1 0.0.0.0 none
set SNMPTrapAddress [index] [xxx.xxx.xxx.xxx] [None |
All | Warning |Critical]
get SNMPTrapAddress [index]
SNTP
Controls whether SNTP time server is used.If
enabled on a data port, a VLAN ID for that port must be
specified.
Default: enabled
set SNTP [enabled | disabled] <[DPn] [VLAN ID]>
SaveConfiguration Restart command required
get SNTP <[DPn] [VLAN ID]>
SNTPServer
Controls or displays the main IP address the client uses
to retrieve the SNTP time.
Default: 192.43.244.18
set SNTPServer[xxx.xxx.xxx.xxx]
SaveConfiguration Restart command required
get SNTPServer
SpeedWrite
Improves the performance of WRITE commands to target
devices attached to the iPBridge. Specify all to set the
Speed Write state for each currently mapped device on
the iPBridge, or to get a list of the Speed Write states of
all currently mapped devices on the iPBridge.
Default: disabled
set SpeedWrite FC [ fp fcindex | all] [enabled | disabled]
get SpeedWrite FC [ fp fcindex | all]
SpeedWriteDefault
Specifies the default
device mappings created manually or using an
operation.
Default: disabled
set SpeedWriteDefault [enabled | disabled]
get SpeedWriteDefault
TailEventLog
Displays new events to the terminal. Type quit then press
ENTER to exit tail mode.
TailEventLog
Temperature
Displays the current internal operating temperature of
this unit in degrees Celsius.
get Temperature
VLAN is
Time
Controls or displays the current time as clocked by the
iPBridge in 24 hour format. Time cannot be set while
SNTP is enabled.
set Time [HH: MM: SS]
get Time
TimeZone
Controls or displays the time zone or an offset from GMT.
Default: EST
set TimeZone [EST | CST | MST | PST] | [+| -] [HH]:[MM]
SaveConfiguration command required
get TimeZone
TraceLog
When enabled, the unit records various system events to
the trace log.
Default: disabled
set TraceLog [enabled | disabled]
get TraceLog
SpeedWrite state applied to new
AutoMap
xii