Figure 22: Console Port Connection - Edge-Core ECS4210-12P Installation Manual

Chapter 6
| Switch Management
How to Connect to the Console Port
◆
Stop bit—One
◆
Data bits—8
◆
Flow control—None

Figure 22: Console Port Connection

Follow these steps to connect to the Console port:
1.
Connect one end of the included RJ-45 to DB-9 serial cable to a DB-9 COM port
connector on a management PC.
2.
Plug in the RJ-45 end of the serial cable to the Console port on the switch.
3.
Configure the PC's COM port required settings using VT-100 terminal emulator
software (such as HyperTerminal) running on the management PC. The switch's
default console port settings are:
115200 bps, 8 data bits, 1-stop bit and no parity
■
4.
Log in to the command-line interface (CLI) using one of the default user login
settings:
User — admin
■
Password — admin
■
or
■ User — guest
Password — guest
■
– 44 –