Using The Time Alignment - Pioneer avh-p7950dvd Operation Manual

Audio Adjustments
When tweeter is selected in the network
mode
Parameter What it does
Selects cut-off frequencies in the fol-
lowing order:
FREQUENCY 1.25k—1.6k—2k—2.5k—3.15k—
4k—5k—6.3k—8k—10k—12.5k
(Hz)
Selects slopes in the following order:
SLOPE
–12— –6 (dB/oct.)
Switches the phase between NOR-
PHASE
MAL and REVERSE.
When front speaker HPF is selected in the
network mode
Parameter What it does
Selects cut-off frequencies in the fol-
lowing order:
FREQUENCY
50—63—80—100—125—160—
200 (Hz)
Selects slopes in the following order:
SLOPE
–18— –12— –6 (dB/oct.)
To switch the filter of the front speaker between LPF and
HPF, touch HIGH PASS or LOW PASS.
When front speaker LPF is selected in the
network mode
Parameter What it does
Selects cut-off frequencies in the fol-
lowing order:
FREQUENCY 1.25k—1.6k—2k—2.5k—3.15k—
4k—5k—6.3k—8k—10k—12.5k
(Hz)
Selects slopes in the following order:
SLOPE
–12— –6—0 (pass) (dB/oct.)
# You can mute the selected speaker unit by
touching MUTE OFF. To cancel muting, touch
MUTE ON.
Notes
! Selecting cut-off frequencies sets cut-off fre-
quencies of the subwoofer's L.P.F. (low-pass
filter) and that of the SMALL speaker H.P.F.
Downloaded from Caradio-Manual.com Manuals
(high-pass filter). The cut-off frequency setting
has no effect if the subwoofer is set to OFF
and other speakers are set to LARGE or OFF.
! If trying to boost the bass output of the sub-
woofer doesn't do much or rather makes you
feel that the bass gets more murky, this may
indicate that the subwoofer's output and bass
content you hear over other speakers cancel
each other out. To remove this problem, try
changing the phase setting for the subwoofer.
! You can store the adjusted setting in memory
by using MEMORY. For details concerning op-
eration, refer to Storing the adjusted audio set-
tings in memory on page 96.

Using the time alignment

The time alignment lets you adjust the dis-
tance between each speaker and the listening
position.
Recalling time alignment settings
% Touch TIME ALIGNMENT on the sound
setting menu to select the time alignment.
Touch TIME ALIGNMENT repeatedly to switch
between the following time alignment set-
tings:
INITIAL—AUTO—CUSTOM1—CUSTOM2—
CUSTOM3—LAST MEMORY—OFF
# You can select LAST MEMORY only when the
adjusted time alignment setting is not memorized
in this unit.
# You cannot select AUTO when NETWORK
has been selected. (Refer to Switching the DSP
setting mode on page 110.)
# When STANDARD has been selected, you
cannot select AUTO if auto TA and EQ has not
been carried out.
Section
17
93
En