Adjusting The Speaker Output Levels Using A Test Tone; Using Time Alignment - Pioneer AVH-P5250BT Operation Manual

Section
13 Menu operations
Note
When you select a cross-over frequency, you are
setting the cross-over frequency for the subwoo-
fer's L.P.F. (low-pass filter) and the Small speak-
er's H.P.F. (high-pass filter). The cross-over
frequency setting has no effect if the subwoofer
is set to Off and other speakers are set to Large
or Off.
Adjusting the speaker output
levels using a test tone
You can easily get the right overall balance
among the speakers with this function.
1 Display the DSP function menu.
Refer to Introduction of menu operations on
page 45.
2 Touch Test Tone.
3 Touch Start to start test tone output.
The test tone is emitted from each speaker in
the following sequence at intervals of about
two seconds. The current settings for the
speaker emitting the test tone will be shown
on the display.
Front-L (left front speaker)—Center (center
speaker)—Front-R (right front speaker)—
Rear-R (right rear speaker)—Rear-L (left rear
speaker)—Subwoofer (subwoofer)
Check each speaker output level. If no adjust-
ments are needed, perform step 5 to stop the
test tone.
# The settings for speakers with the size set to
Off will not be displayed. (Refer to Setting the
speaker setting on page 52.)
4 Touch c or d to adjust the speaker out-
put level.
Range: +10 to –10
# The test tone will be emitted from the next
speaker after about two seconds after the last op-
eration.
5 Touch Stop to end test tone output.
54
En
Notes
! If necessary, select speakers and adjust their
'absolute' output levels. (Refer to Adjusting
the speaker output levels on the previous
page.)
! You will get the same results whether you ad-
just the speaker output levels with this mode
or with Speaker Level.

Using time alignment

The distance between the listening position
and each speaker can be adjusted with this
function.
1 Display the DSP function menu.
Refer to Introduction of menu operations on
page 45.
2 Touch Time Alignment.
3 Touch any of the following touch panel
keys to select the time alignment.
! Initial – Initial time alignment (factory set-
ting)
! Auto TA – Time alignment created by auto
TA and EQ. (Refer to Auto TA and EQ (auto-
time alignment and auto-equalizing) on
page 56.)
! Custom – Adjusted time alignment that
you can create
! Adjustment – Enables adjusting the time
alignment as desired
! Off – Turns Time Alignment off
# You cannot select Auto TA if auto TA and EQ
have not been carried out.
# Adjustment can only be selected when either
Front-L or Front-R is selected in Position.
Adjusting time alignment
The distance between the selected position
and each speaker can be adjusted.
! The adjusted time alignment is stored in
Custom.