Theory of Operation
USER OPERATION
Before operating drawer microwave, make certain you read and understand the operation instructions completely.
Before the drawer microwave can be used, follow these steps:
1. Plug in drawer microwave.
display (See Figure 3-1).
2. Touch the STOP/CLEAR pad (See Figure 3-1).
3. Set clock (proceed to steps below).
TO SET THE CLOCK (See Figure 3-2):
1. Touch TIMER/CLOCK pad.
number two (2).
2. Touch number pads for correct time of day then, touch TIMER/CLOCK pad again.
This is a 12 hour clock. If you attempt to enter an incorrect clock time,
STOP/CLEAR pad and re-enter the time.
If the electrical power supply to your drawer microwave should be interrupted, the display will intermittently show
enjoy your
micro- wave
ing cooking, the program will be erased. The time of day will also be erased. Simply touch the STOP/CLEAR pad
and reset the clock for the correct time of day.
NOTE: The drawer microwave can be programmed with the drawer open except for START/ADD MINUTE.
TIMER (See Figure 3-3):
1. Touch TIMER/CLOCK pad.
number one (1).
2. Enter time.
3. Touch TIMER/CLOCK pad again. To cancel timer, touch STOP/CLEAR pad.
#813632 - Revision B - December, 2009
Drawer Microwave
enjoy your
micro- wave
:
Figure 3-1. Getting Started
to set timer
press 1 to set clock
touch
clear
and
touch
Figure 3-2. Setting the Clock
to set timer
press 1 to set clock
Figure 3-3. Setting the Timer
(Models MWD24-2 / MWD30-2)
touch
clear
and
will appear in the display.
will appear in the display. Press the
press 2
will appear in the display. Touch the
error
after the power is reinstated. If this occurs dur-
clock
Touch TIMER/CLOCK pad and then the number 2
press 2
will appear in the display. Press the
Touch TIMER/CLOCK pad and then the number 1
3-2
will appear in the
touch
clock