Wolf MWD24-2 Service Manual page 12

Installation Information
Wall Oven
Cutout
Electrical
Outlet
Location
84"
(2134)
Wall
Cabinet
28-7/16"(722)
D
Opening
A
B
30"(762)
Cabinet Min
Drawer Installation
Place the drawer adjacent to the wall or cabinet opening. Plug the power supply cord into the electrical outlet.
Carefully guide the drawer into the prepared opening. NOTE: Avoid pinching the cord between the oven and the
wall. Slide the drawer all the way until the mounting flange is flush with the face of the cabinet. With the drawer
open, use the four mounting holes on the drawer as a template. Pre drill the cabinet using a 1/16"(1.6mm) drill bit.
Then, secure the drawer with the four mounting screws supplied (See Figure 2-6).
Slide drawer all the way back until
mounting flange is flush with face of
cabinet. Being careful not to pinch
cord. With drawer open, use
mounting four holes as a template.
Mounting Flange
#813632 - Revision B - December, 2009
Drawer Microwave
A = Allow 3/4"(19) Overlap
B = 23-1/2"(597) Depth Min
C = Allow 3/4"(19) Overlap
D = 4"(102)
E = 5"(127)
F = Allow 7/16"(11) Overlap
G = 14-13/16"(376) Opening
H = Allow 3/16"(5) Overlap
6"(152)
Anti-Tip Block
3-1/16"
(78)
E
2"
14-13/16"(376) to
(51)
H
Min
bottom of anti-tip block
C
G
F
19"(483) to top of floor
(recommended)
Figure 2-5. 30" Drawer Microwave Install Specifications
Figure 2-6. Drawer Microwave Installation (MWD24 shown)
(Models MWD24-2 / MWD30-2)
A = 23-1/2"(597) Depth Min
B = Allow 3/4"(19) Overlap
C = Allow 7/16"(11) Overlap
D = 14-13/16"(376) Opening
E = Allow 3/16"(5) Overlap
Electrical Outlet
Location
28-7/16"(722)
Opening
Allow 3/4"(19)
Overlap
36"
A
(914)
Countertop
Height
30"(762)
Cabinet Min
Mounting Screw
2-4
6"(152)
3-1/2"
(89)
5"(127)
4"(102)
14-13/16"(376)
to bottom of
E
anti-tip block
D
B
C
19"(483) to top of floor
(recommended)
Pre-drill mounting holes
then, secure drawer with
four screws supplied.
Two on each side.
Anti-Tip
Block