Side Panel Installation - Regency CS2400 Owners & Installation Manual

Owners & installation manual (32 pages)

Table of Contents

One set of side panels needs to be installed on the stove. When installing stainless steel side panels - follow the handling and cleaning instructions below.

Before installation, panels must be handled and cleaned as per instructions noted below:

•

Stainless panels must be inspected for scratches and dimples prior to installation. All claims to be recorded at this time.

Claims for damage after installation will not receive consideration.

•

To protect the ﬁ nish during installation and handling - cotton gloves MUST be worn at all times while handling the panels (even when

removing protective coating).

•

Use a hair dryer to remove the protective coating from the panels.

•

Stainless panels will discolor a little during normal operation.

This is normal and should not be considered a defect.

All hand and ﬁ nger marks MUST be cleaned off with a soft cloth and a stainless steel cleaner. Most stainless steel cleaners leave a ﬁ lm/

residue on the surface of the panels. Use an ammonia based cleaner (ie. glass cleaner) to remove this ﬁ lm before applying heat to the unit.

Failure to do this will result in burn stains on panels which you will be unable to remove. Not protected by product warranty.

1) Bend the metal tab (located in the top front corner of the side panels to

a 45° angle - with a pair of pliers.

Note:

Do not bend the tab back and forth - as this will weaken the

metal.

2) Remove cast top - carefully place off to the side.

3) Position the left side panel - so the tab rests on the side panel bracket

on the unit.

** Left panel can be identiﬁ ed by the 2 small holes near the bottom for the

logo plate - see diagram 1.

Side Panel

Tab

918-918