Page 1
CS2400 Alterra ® Freestanding Wood Stove Owner's & Installation Manual Tested by: Installer: Please complete the details on the back cover and leave this manual with the homeowner. Homeowner: Please keep these instructions for future reference. FPI FIREPLACE PRODUCTS INTERNATIONAL LTD. 6988 Venture St., Delta, BC Canada, V4G 1H4 919-545 05.15.15...
Page 2
The following statements are required by the Environmental Protection Agency: “This manual describes the installation and operation of the Regency CS2400 wood heater. This heater meets the 2015 U.S. Environmental Protection Agency’s crib wood emission limits for wood heaters. Under specific test conditions this heater has been shown to deliver heat at rates ranging from 12,000 BTU/hr. to 36,800 BTU/hr.”...
This is a copy of the label for reference only, that accompanies each CS2400 Wood Stove. We have included a copy of the contents here for your review. NOTE: Regency units are constantly being improved. Check the label on the unit and if there is a difference, the label on the unit is the correct one.
(left to right side opening) ..........19 Cast Door reversal (left to right side opening) .....20 Wood Storage .............21 Ashlip installation ............21 Optional outdoor Air kit installation ......22 Blower/Fan installation ..........23 Fan Operation..............23 Fan wiring ..............23 Regency CS2400 Freestanding Wood Stove...
CAUTION: The chimney should be the same size as the flue outlet on the stove. The chimney must be 13) Your Regency Wood stove is not to be connected Ashlip Installation listed as suitable for use with solid fuels. For other to any air distribution duct.
Mobile Home Close Clearance (To be installed with required pipe components) "C" Vent single wall pipe is not approved for Mobile Home installations. (Refer to Mobile Home Instructions.) From Unit From Corner From Flue Center-line CS2400 15" 6.5" 6" 28" 14-7/8" 18-11/16" Regency CS2400 Freestanding Wood Stove...
MEASUREMENTS "FROM UNIT" ARE FROM THE SIDE SHIELDS OF THE STOVE TO A SIDE WALL OR TO A CORNER, AND FROM THE REAR HEAT SHIELD TO A BACK WALL The Regency Freestanding models have been alcove approved and must be installed with a listed double wall connector to the ceiling level.
6) Fasten the raincap with spark screens (if re- quired) to the top of your chimney. 7) For optimum efficiency when installing into a masonry chimney, size accordingly, i.e. the 6" (152mm) flue dia. is 28.28 sq.in. Horizontal Installation Regency CS2400 Freestanding Wood Stove...
The chimney must be the required height above the roof or other obstructions for safety and proper draft operation. The space heater is to be connected to a factory-built chimney conforming to CAN/ULC-S629, Standard for 650 C Factory-Built Chimneys. 10 | Regency CS2400 Freestanding Wood Stove...
24 gage minimum sheet metal supports. See that the supports are fastened securely to wall surfaces on all sides. Make sure fasteners used to secure chimney flue liner. Regency CS2400 Freestanding Wood Stove...
1) Bend the tabs on the rear heat shield outwards 90 degrees. 2) Secure the tabs on the top of the rear heat shield with ¼” hex screws, supplied. Left and right tabs - bent at 90° Installed Pipe Shield Regency CS2400 Freestanding Wood Stove...
MOBILE HOME INSTALLATION The Regency CS2400 is approved for installation in a Mobile Home if one of the following pipe systems is used. A chimney complying with the requirements for type HT chimney, factory built, Residential type and Building Heating appliance, (UL103, ULCS629, OR2) code- approved masonry chimney with a flue liner U.S.
WARNING: Operation of the unit with out proper installation of smoke deflector will void warranty. Ensure defector is seated so bolts are situated at the top of the keyhole before tightening. Regency CS2400 Freestanding Wood Stove...
If it is not enough space then remove the middle air in wood storage area. tube (reverse the procedure in step 1) above), and baffle and then replace everything when cleaning is completed. 16 | Regency CS2400 Freestanding Wood Stove...
Failure to do this will result in burn stains on panels which you will be unable to remove. Not protected by product warranty. 4) Install Regency logo on to the 1) Bend the metal tab (located in the top front corner of the side panels to left side panel - by snapping a 45°...
5) Remove and rotate both the male part of the latch 180° - located on the inside of the lower surround door. Install the latch on the opposite side of the door. Door latch - male portion Regency CS2400 Freestanding Wood Stove...
4) Flip the door hinge 180° - install on the left side of the unit with 2 bolts. 5) Reattach the door catch assembly on the right side with 2 bolts from step Door 9) Reattach the door to the door hinge. Hinge Door Catch 20 | Regency CS2400 Freestanding Wood Stove...
Note: Please refer to local codes. (B365, NFPA 211) and your local jurisdiction.. Tabs on ashlip Store wood behind opening ASHLIP INSTALLATION 1) Open lower surround door. 2) Ashlip to be positioned just below the ashdrawer (if installed). Final install of Ashlip Ashlip to be positioned here Regency CS2400 Freestanding Wood Stove...
Secure with 4 self tapping screws. plate. 3) Reinstall the backing plate over the air kit pipe. Secure with 4 screws removed from step 1. 4) Slide cap over end to pipe to complete the installation. 22 | Regency CS2400 Freestanding Wood Stove...
CAUTION: Label all wires prior to disconnection hazard and should be plugged directly into a properly when servicing controls. Wiring errors can cause grounded three-prong receptacle. Do not cut or remove improper and dangerous operation. the grounding prong from this plug. Regency CS2400 Freestanding Wood Stove...
Two dry pieces banged together sound hollow; wet pieces sound solid and dull. • Dry wood weighs much less than wet wood. • Split a piece of wood. If the exposed surface feels damp, the wood is too wet to burn. 24 | Regency CS2400 Freestanding Wood Stove...
(Leaving Regency Stove causing a draft down your the door slightly open will help your fire start chimney. If this occurs, slightly open a window more rapidly.)
2) Always leave 1/2 to 1 inch of ash in the bottom of the firebox. This helps in easier starting and a more uniform burn of your fire. Replace ash plug when ashes have been removed. 26 | Regency CS2400 Freestanding Wood Stove...
SAFETY GUIDELINES AND ance. House fire and property damage may 7) Your Regency stove can be very hot. You may result if combustible items are stored within the WARNINGS be seriously burned if you touch the stove required clearances.
4) A small hot fire is preferable to a large smoul- dering one that can deposit creosote within the system. Your Regency stove is supplied with 5 mm Neoceram ceramic glass that will withstand the highest heat 5) Check the chimney at least twice a month dur- that your unit will produce.
Fan Bracket Left Hand 200-229 Fan Housing Back 910-157/P Fan 910-142 Thermodisc FIRE BRICK / AIR TUBE / BAFFLE Part # Description 020-960 Firebrick Set 033-953 Air Tube - 3/4" (Qty: 4) 020-957 Baffle (set) 30 | Regency CS2400 Freestanding Wood Stove...
The authorized selling dealer is responsible for all in-fi eld service work carried out on your Regency product. FPI will not be liable for results or costs of workmanship from unauthorized service persons or dealers.
Page 32
Register your Regency warranty online ® www.regency-fire.com Reasons to register your product online today! • View and modify a list of all your registered products. • Request automatic email notification of new product updates. • Stay informed about the current promotions, events, and special offers on related products.