Installation; Installing The Camera - Ganz PIXELPRO SERIES Installation Manual

PixelPro GXi Series

4. INSTALLATION

4.1. Installing the camera

Roll-up
String
Holder
hole
To prevent products from damage, place the camera on stable and non-vibrating
!
surfaces. If the stability is in doubt, consult safety personnel for reinforcements,
and then proceed with the installation.
Caution
04-2014-A
32-pin socket
ZN-PTZ202XE Installation Guide
1) Open the camera's main top by
twisting it counter-clockwise.
2) Detach the roll-up string from the
main body to separate the main top
from the main body, and securely place
the main body on a stable surface.
3) Drop all the necessary cables from
the ceiling.
4) Push the lever inside the camera's
main top inward to detach the center
part (PCB board) from the rest of the
main top.
5) Fix the main top to the ceiling by
inserting and tightening the three
screws into the holes.
6) Connect the cables to the connectors
and the terminal blocks on the PCB
board of the main top, and reattach the
center part by pushing back the lever to
the camera's main top.
7) Pull up the roll up string from inside
of the camera's main top, and insert it
to the roll-up string holder on the
camera's main body while carefully
holding the main body.
8) Attach the main body and the main
top by aligning the triangle marks on
both parts.
9) Twist the main body counter-
clockwise once the two parts are
properly aligned.
7