Maintenance; Troubleshooting - Gardena THS Li-18/42 Operating Instructions Manual

7. Maintenance

w
Cleaning the Hedge Trimmer:
w

8. Troubleshooting

w
Problem
Hedge trimmer does not start
Hedge is not cleanly cut
The Hedge Trimmer can no
longer be switched off
Hedge Trimmer stops.
ß
Error-LED flashes
W
20
DANGER! Risk of physical injury!
Cutting injuries can be caused if the hedge trimmer
does switch on unintentionally.
e
v B efore maintenance, remove the battery
(see 4. Initial Operation) and slide the protective
cover
ATTENTION ! Damage to the hedge trimmer!
v N ever clean the hedge trimmer under running water
or with a water jet (in particular a high pressure
water jet).
1. Clean the hedge trimmer with a damp cloth.
e
2. Clean the airflow slots with a soft brush
(do not use a screwdriver).
3. Clean the blade
a low-viscosity oil (e.g. GARDENA Spray Oil Art. 2366).
Avoid contact of the oil with the plastic parts and wear gloves.
DANGER! Risk of physical injury!
Cutting injuries can be caused if the hedge trimmer
does switch on unintentionally.
e
v R emove the battery before troubleshooting
(see 4. Initial Operation) and slide the protective
cover
Possible Cause
Battery is flat.
Battery not pushed onto the
handle properly.
Blade soiled (e. g. by resin).
Blade blocked.
Blade blunt or damaged.
Start button is stuck.
Battery overload.
w
over the cutter blade
e
with a brush, if required, and lubricate with
w
over the cutter blade
Remedy
v Charge battery
(see 4. Initial Operation).
v Push battery onto the
handle and make sure that
the locking buttons snaps
in correctly.
v Clean blade
(see 7. Maintenance).
v Remove obstacle.
v Have blade replaced by
GARDENA-Service.
v Remove battery and loosen
start button.
v Wait for 10 sec.
Press button
battery and restart.
e
.
e
.
ß
on the
B