Table of Contents
Advertisement
Security
The NF10W supports all encryptions within the 802.11 standard. The factory default is WPA2-PSK. The NF10W also supports
WPA, WPA-PSK, WPA2, WPA2-PSK. You can also select to enable WPS mode.
The following parameters are available:
PARAMETER
Enable WPS
Select SSID
Network Authentication
WPA/WAPI passphrase
WPA Group Rekey Interval
WPA/WAPI Encryption
WEP Encryption
Note: WPA with TKIP and Open WEP are no longer considered secure. WPA2 with AES is the most secure option.
Mixed WPA2/WPA (TKIP+AES) will provide maximum compatibility with legacy devices.
Click Apply/Save to save the new wireless security configuration settings.
MAC Filter
MAC Filter allows you to add or remove the MAC Address of devices which will be allowed or denied access to the wireless
network. First use the Select SSID drop down list to select the wireless network you wish to configure, then select to either allow or
deny access to the MAC addresses listed.
www.netcommwireless.com
v1.1
Select to enable or disable the WPS function of the NF10W.
Select the SSID to apply the security settings to.
Select the Wireless security type to use with the wireless network.
Enter the security key to use with the wireless network.
Enter the group rekey interval. This should not need to change.
Select the type of encryption to use on the wireless network.
Select to utilise WEP encryption on the wireless network connection.
DEFINITION
NetComm Wireless NF10W User Guide
52
Hide quick links:
Advertisement
Table of Contents
