Lap-Shoulder Belt Installation - Britax BOULEVARD User Manual

BRITAX Child Safety, Inc.

Lap-Shoulder Belt Installation

1. Loosen the harness.
a. Lift harness adjuster
lever and pull both
harness straps
forward.
b. Remove the infant
positioning pillow
and unbuckle the
harness.
2. Attach the anti-rebound
bar (see page 26).
3. Recline the unoccupied
child seat to position 3
and place rear-facing on
the vehicle seat (see page
24).
4. Pull the head restraint
cover up, then pull the
seat cover forward to
access the rear-facing
belt path.
5. Open the blue lock-
off closest to where
the vehicle belt will be
buckled.
a. Open the locking tab.
b. Open the clamp.
6. Route the vehicle belt
through the rear-facing
belt slots, ensuring that
the vehicle belt is routed
under the harness buckle
strap.
NOTE: The buckle should
be in the inner slot.
7. Ensure the vehicle belt
is not twisted and buckle
the seat belt.
10
5b
5a
Clamp
Locking
Tab
BOULEVARD Canadian User Guide
8. Push down into the
middle of the child
seating area with
moderate force while
removing all slack from
the bottom (lap) part of
the vehicle belt and close
the lock-off, if used (see
page 24).
IMPORTANT: Both the
vehicle lap and shoulder
belts must be routed
through the lock-off.
9. Push down into the middle
of the child seating area
with moderate force while
pulling the top (shoulder)
part of the belt between
the belt slots to remove
any remaining slack
through the lock-off.
10. Replace the seat cover.
Rear-Facing Installation with Lap-Shoulder Belt
9 Check that all connections are secure and straps are not
twisted.
9 Ensure that the anti-rebound bar is properly installed
(see page 26).
9 Check that the child seat cannot be moved front to back
or side to side more than 2.5 cm (1 in.) at the belt path.
If the child seat is not secure, repeat installation or use a
different seating location.
9 Check that the back angle of the child seat is 30° – 45°
from vertical (not to exceed 45°) when the car is parked
on a level surface. See "Seat Positions" on page 24.
11