Britax BOULEVARD User Manual page 19

BRITAX Child Safety, Inc.
b. Has a retractor that
stops the belt from
being pulled out again
once the belt webbing
has been pulled out at
least 61 cm (24 in.).
c. Tightens by feeding
the belt webbing
back into the
retractor.
2. ELR (Emergency Locking Retractor) with Locking Latch
Plate
a. Has a latch plate
that locks the vehicle
belt.
NOTE: Ensure the latch
plate and vehicle belt
lie flat against the child
seat or the vehicle belt
may remain unlocked.
b. Has a retractor that
locks only in an
emergency situation
such as sudden stop
or crash.
3. Switchable Retractor with Sliding Latch Plate
a. Has a latch plate that
freely slides along
the vehicle seat belt
webbing.
b. Has a retractor that
can be switched
to function as an
ALR. Pull the belt all
the way out of the
retractor to set the
automatic locking
function.
NOTE: To use a child
seat with this type of
vehicle seat belt, you
will need to switch to
the ALR mode or use
child seat lock-offs.
32
4. ELR (Emergency Locking Retractor) with Sliding Latch
5. Switchable Retractor with Sewn Latch Plate and
Latch
plate
Latch
Lap Belt
plate
1. ALR (Automatic Locking
BOULEVARD Canadian User Guide
Plate
a. Has a latch plate that
freely slides along
the vehicle seat belt
webbing.
b. Has a retractor that
locks only in an
emergency situation
such as sudden stop
or crash.
IMPORTANT: This belt type requires the use of the
lock-offs built into the seat for rear- and forward-facing
installations. See page 24 for information on lock-offs.
Inflatable Seat Belt
NOTE: This BRITAX car seat may not be compatible
with every inflatable lap-shoulder belt. See FAQS in the
support section of the BRITAX website (www.britax.ca/
support) for additional instructions.
a. Has a latch plate
that is sewn into the
webbing.
b. Has a retractor that
can be switched to
function as an ALR
by pulling the vehicle
lap belt fully out until
a clicking sound
can be heard when
retracting.
NOTE: To use a child
seat with this type of
vehicle belt, you will
need to switch the
retractor for the lap
section of the seat belt
to the ALR mode.
Retractor)
a. Has a latch plate
that is sewn into the
webbing.
b. Has a retractor that
stops the belt from
being pulled out again
once the belt webbing
has been pulled out at
least 61 cm (24 in.).
Latch Plate
Inflatable Lap
Shoulder Belt
Latch
plate
33