Table of Contents
Advertisement
10-2. Auto Cutter Specifications
() Cutting frequency
() Thickness of paper
10-3. Interface
RS-C serial interface/Two-way parallel interface (IEEE)/USB interface/Ethernet in-
terface/Wireless LAN Interface
10-4. Electrical Characteristics
() Input Voltage
() Current Consumption (DC V at room temperature)
Standby:
ASCII printing:
00% print duty:
() Power Connector
Pin No.
Drive power ( V)
Shell
Frame ground
Note:
• When using a printer power supply other than the optional AC adaptor (PS60A-A),
be sure that the following cautions are observed.
• Use a power supply of DC V ±0% and more than .0 A (.0 A Load 0 sec. Min)
with LPS output approved by IEC600.
• Be careful about installing the printer in an area where there is noise. Take the appropri-
ate measures to protect against electrostatic AC line noise, etc.
Max. 0 cuts per minute
0.06 ~ 0. mm
DC V±0%
(Approx. .% printing rate)
(Solid printing):
(Continuous solid printing should be 0 seconds or less.)
Function
Signal GND
N.C.
Approx. 0. A
Approx. average . A
Approx. peak . A
Approx. average .0 A
<Viewed from Connector Surface>
– 6 –
Advertisement
Table of Contents
