Table of Contents
Advertisement
3-2-4. Connecting Ethernet Cable
When using an Ethernet cable that is 0 m or less,
shielded cable is recommended.
() Make sure the printer is turned off.
(2) Affix the ferrite core onto the ethernet cable as
shown in the illustration below.
() Pass the fastener through the ferrite core.
() Loop the fastener around the cable and lock it.
Use scissors to cut off any excess.
Ferrite core
() Connect the interface cable to the connector on
the rear panel of the printer.
Ethernet cable
Fastener
10 cm
(maximum)
– –
Advertisement
Table of Contents
